Mobile tyre fitting in Dubai, Sharjah & Abu DhabiSplit any order into 4 with Tabby or Tamara +971 50 623 0997

Illustrated guide

Causes of Tyre Damage: A Symptom-by-Symptom Diagnosis Guide

Start with what you can see or feel, find the likely cause, and know straight away whether the tyre can be repaired or must be replaced. This is the same order of thinking our technicians use at the roadside.

Written by Hassan Faaz · Updated 12 November 2026

Tyre technician, 8 years fitting and repairing tyres in the UAE

How to use this diagnosis guide

Tyre damage falls into three groups: injuries (something cut or pierced the tyre), structural failures (the casing has been broken internally, usually by an impact or heat), and wear patterns (the tyre is fine but something about the car or how it is maintained is wearing it unevenly). Each group needs a different response.

Where damage happens on a tyre, and which zones can be repaired.
Stop driving now if you see any of these

A bulge or blister on the sidewall, exposed cords or steel wire, a tyre that is visibly flat or losing air fast, a cut deep enough to see inside, a strong vibration that started suddenly, or a smell of hot rubber. Pull over somewhere safe, switch on hazard lights and call for help rather than driving on it.

Use the table in the next section to find your symptom, then read the detailed section below it. If you are still unsure, send a photo by WhatsApp from our contact page; a clear picture of the sidewall and tread often tells us enough to advise.

The diagnosis table: symptom, cause, verdict

Common tyre problems seen in the UAE
SymptomLikely causeRepairable?What to do
Nail or screw in the tread, tyre holding airDebris from construction sites and roadsidesUsually yes, if in the central tread and 6 mm or smallerLeave it in, check pressure, book a puncture repair
Pressure drops a few psi every few daysSlow puncture, leaking valve, bead or rim sealUsually yes, once the source is foundHave it leak-tested in water
Bulge or bubble on the sidewallImpact broke internal cords; air pushes into the rubberNoReplace the tyre; avoid driving at speed
Cut or gash in the sidewallKerb, sharp rock, debrisNoReplace; even shallow sidewall cuts weaken the casing
Fine cracks on sidewall or between tread blocksAge, UV and ozone, heat, petroleum dressingsNoMonitor if shallow; replace if deep or the tyre is over 5 years old
Inner or outer edge worn smoothCamber or toe out of specificationTyre no; car yesWheel alignment; replace the tyre if below limit
Centre of tread worn faster than the edgesOverinflationTyre no; habit yesSet pressure to the placard figure
Both shoulders worn, centre fineUnderinflation or overloadingTyre no; habit yesCorrect pressure, check for slow leaks
Scalloped dips around the tread (cupping)Worn shock absorbers or unbalanced wheelTyre noSuspension check and wheel balancing
Tread blocks sharp on one side, smooth on the other (feathering)Toe misalignmentTyre noWheel alignment
Flat spot, vibration at certain speedsLocked-wheel braking, or long parking without movingSometimes settles; often noInspect; replace if a skid patch is visible
Tyre will not hold air at the rim edgeBead damage, corroded rim, poor fittingSometimesRemove, inspect bead, clean or repair rim
Split or dented rim, tyre losing airPothole or speed bump impactRim often yes; tyre needs inspectionRim repair and inspect the tyre inside
Scrapes on the sidewall and rim edgeKerb rash while parkingRim yes; tyre depends on depthInspect; replace the tyre if cords show
Valve hisses or is crackedPerished rubber valve or loose TPMS valve coreYesReplace the valve
Tyre burst at speedUnderinflation, heat, overload, or an earlier impactNoFit the spare safely; replace and check the other tyres

Punctures, nails and slow leaks

A nail in a tyre is the most common thing we are called out for. Dubai and Sharjah have constant construction, and screws and roofing nails end up on service roads, car park ramps and the edges of motorways. Most go into the tread at an angle and seal partly around themselves, which is why the tyre often loses air over days rather than minutes.

  • Do not pull the nail out yourself. It is plugging the hole. Removing it at home can turn a slow leak into a flat.
  • Check pressure daily until the repair, and drive gently.
  • Do not run on it flat. Even a few hundred metres on a deflated tyre can crush the sidewall from the inside and turn a simple puncture repair into the cost of a new tyre.
Repairable zone
The central tread area only, not the shoulders or sidewall
Maximum injury size
Typically up to 6 mm diameter for car tyres
Spacing
Repairs should not overlap; two holes very close together usually mean replacement
Correct method
Tyre removed from the rim, inspected inside, and repaired with a combination plug-patch
Run-flat tyres
Repair rules vary by tyre maker; some do not allow repair at all

Usually repairable

  • Nail or screw in the central tread
  • Hole 6 mm or smaller
  • Tyre has not been driven flat
  • No previous repair close by
  • Tread above the legal limit

Replace instead

  • Any puncture in the shoulder or sidewall
  • Hole larger than about 6 mm, or a tear
  • Inner liner shows rub marks from driving flat
  • Overlapping or multiple close repairs
  • Tyre already near the end of its life

Our puncture repair starts from AED 40 per puncture, with the final price depending on the tyre and location. For the difference between a quick external plug and a proper internal repair, read plug versus patch.

Flat tyre but no puncture: the hidden reasons

If a tyre keeps going flat and nobody can find a nail, the air is escaping somewhere else. These are the reasons for a flat tyre we find most often when the tread looks perfect.

  1. Valve stem. Rubber valves harden and crack in UAE heat, often at the base where you cannot see. A loose or corroded valve core leaks too.
  2. Bead seal. Corrosion or old rubber residue on the rim edge stops the tyre sealing. Common on alloy wheels that have been through several tyre changes.
  3. Rim damage. A small bend from a pothole or speed bump can open a gap between tyre and rim, especially when cornering.
  4. Porous alloy. Some older cast wheels leak slowly through the metal itself.
  5. TPMS sensor seal. The rubber grommet or nut on a direct sensor can leak after a tyre change.
  6. Heat and time. Every tyre loses some air naturally. A car that has not been checked for three months may simply be low, with nothing wrong at all.

The way to find it is to remove the wheel, inflate it, and submerge or spray it with soapy water. Our flat tyre repair starts from AED 60 and includes finding the leak, not just topping it up.

Sidewall bulges and cuts

A tyre bulge looks like a blister or egg on the side of the tyre. It means the cords inside the sidewall have snapped, usually from an impact that pinched the tyre between the rim and an edge such as a pothole lip, a speed bump taken too fast, or a kerb. Air pressure then pushes the outer rubber outward through the gap. The tyre may hold air perfectly, but it has lost its strength at that point and can fail without warning.

There is no safe tyre sidewall repair

The sidewall flexes constantly as the tyre rolls, and no patch can restore the broken cords. Any shop offering to repair sidewall damage is putting you at risk. Replace the tyre, and in the UAE remember that a tyre with a visible bulge fails RTA vehicle inspection; see our RTA tyre rules post.

Sidewall cuts follow the same rule. A scrape that only marks the outer rubber may be cosmetic, but if you can see fabric or cords, or the cut opens when you squeeze it, the tyre must be replaced. Low-profile tyres are especially vulnerable because there is so little sidewall between the rim and the road. Our detailed article on tyre bulges shows examples.

Impact damage: potholes, speed bumps and kerbs

Most structural damage starts with a single hard hit. In the UAE the usual culprits are speed bumps in residential communities taken too quickly, the sharp edges of basement car park ramps, kerbs in tight parking bays, and the occasional pothole or expansion joint on older roads.

ImpactWhat it does to the tyreWhat it does to the wheel
Speed bump at speedPinches sidewall against rim; can cause a bulge days laterCan bend the inner rim lip
Pothole edgeImpact break inside the casing, sometimes a cutBent or cracked rim, knocks alignment out
Kerb strike while parkingScuffs and cuts on the sidewallKerb rash on the rim face
Kerb strike while movingBulge, internal breakBent rim, suspension and alignment damage
Debris on the motorwayCuts, punctures, impact breaksDents

Impact breaks do not always show at once. A bulge can appear a day or a week later. After any hard hit, check the sidewall again over the following days, and get the alignment checked if the steering wheel is no longer straight. Bent and kerbed rims can often be fixed through our rim repair service, starting from AED 150 per rim.

Cracks, dry rot and age

Tyre cracks are the UAE's signature damage. Sunlight, ozone and heat break down the rubber's surface and the protective waxes that the compound releases as the tyre rolls. A car parked outdoors for weeks in summer suffers more than one driven daily, because the waxes only migrate to the surface when the tyre flexes.

AppearanceSeverityAction
Very fine surface lines, only visible close upCosmeticMonitor every month
Visible cracks you can catch a fingernail inModeratePlan replacement, avoid high speeds and heavy loads
Deep cracks, especially at the tread base or around the beadSevereReplace now
Any cracking on a tyre more than 5 years oldAge-relatedReplace, whatever the tread depth

Tyre shine products made with petroleum solvents speed up cracking by drawing out the oils that keep rubber supple. Our tyre care tips cover cleaning, shading and parking habits that slow ageing down.

Uneven wear patterns and what they reveal

Wear patterns are a message from the car. The tyre is a symptom; the cause is usually alignment, pressure, suspension or balance. Replacing the tyre without fixing the cause means the new one will wear the same way.

Camber and toe angles, the two settings behind most edge and feathered wear.
  1. One edge worn (inner or outer)

    Usually camber or toe is out. Inner edge wear is very common on cars that hit speed bumps hard or have lowered suspension. Fix with a wheel alignment.

  2. Centre worn

    The tyre has been run overinflated, so only the middle has been touching the road. Reset to the placard pressure.

  3. Both shoulders worn

    Underinflation or regular overloading. Check for slow leaks and start monthly pressure checks.

  4. Cupping or scalloping

    Dips around the tread at regular intervals. Worn shock absorbers let the wheel bounce, or a wheel is out of balance. Needs a suspension check and balancing.

  5. Feathering

    Run your hand across the tread: smooth one way, sharp the other. That is toe misalignment scrubbing the tyre sideways.

  6. Flat spots

    A worn patch from a locked-wheel skid, or a temporary flat spot from parking for weeks. Temporary ones often ease after driving; a skid patch does not.

Bead and valve damage

The bead is where the tyre meets the rim, and it is the one part of the tyre that is damaged mostly by people rather than roads. Forcing a tyre on or off with the wrong tools or without lubricant can tear the bead rubber or kink the steel wire inside it. A kinked bead cannot seal or hold the tyre securely, and the tyre must be scrapped.

  • Signs of bead damage: slow leak at the rim edge, visible tears or missing rubber on the bead, a wheel that will not balance properly.
  • Valve problems: rubber snap-in valves perish in heat and should be replaced at every tyre change. Metal TPMS valves need new seals and the correct torque.
  • Missing valve caps: let sand and grit into the valve core, causing slow leaks. A cap costs almost nothing.

Burst tyres: why they happen and what to do

A burst tyre at motorway speed is frightening but rarely random. In almost every burst tyre we inspect, one or more of these factors was present: the tyre had been running underinflated, the car was heavily loaded, it was a hot day at sustained speed, the tyre was old or cracked, or an earlier impact had weakened the casing.

  1. Hold the wheel firmly

    Keep the car straight. The car will pull towards the burst side.

  2. Do not brake hard

    Ease off the accelerator and let the car slow down gradually. Braking hard can make the car swerve.

  3. Signal and move over when slow

    Head for the hard shoulder or the nearest safe place once the speed is down.

  4. Hazard lights and warning triangle

    Get everyone out on the side away from traffic and stand behind the barrier if there is one.

  5. Change the wheel only if it is safe

    On a busy motorway it often is not. Call for roadside help instead.

Our flat tyre on the highway article has more on staying safe, and for night-time problems there is our 24-hour tyre repair in Dubai. After a burst, have the other tyres checked too: they have been through the same conditions.

Questions people ask

Can a tyre bulge be repaired?

No, a tyre bulge cannot be repaired. It means the cords inside the sidewall have broken, usually from an impact, and the tyre can fail without warning. Replace it as soon as possible and avoid high speeds until then.

Can I drive with a nail in my tyre?

You can usually drive a short distance to a repair if the tyre is still holding air, but do not pull the nail out yourself. Check the pressure, drive gently, and get it repaired soon. If the tyre is losing air quickly or is flat, do not drive on it.

Is tyre sidewall repair safe?

No. The sidewall flexes with every rotation and no repair can restore the broken cords, so any sidewall damage that goes beyond the surface rubber means replacement. Punctures can only be repaired in the central tread area.

Why is my tyre flat but there is no puncture?

A flat tyre with no puncture is usually caused by a leaking valve, a poor seal between the tyre bead and the rim, a bent or corroded rim, or a leaking TPMS sensor seal. A leak test with the wheel off the car finds the source.

What causes a slow puncture?

A slow puncture is most often a small nail or screw partly sealing its own hole, though a cracked valve or a bad bead seal can act the same way. If a tyre needs topping up every few days, have it leak-tested rather than just adding air.

What causes a tyre to burst?

Most burst tyres are caused by underinflation combined with heat and speed, with overloading, old cracked rubber or earlier impact damage making it worse. Regular pressure checks and replacing aged tyres prevent most bursts.

Are small tyre cracks dangerous?

Very fine surface cracks are usually cosmetic, but cracks deep enough to catch a fingernail mean the rubber is breaking down and the tyre should be replaced soon. Any cracking on a tyre more than five years old is a reason to replace it in UAE heat.

Send your tyre size, get three prices

WhatsApp a photo of your tyre or your car model. We reply with a value, mid-range and premium option, fitted where you park.

Chat on WhatsApp
Call now WhatsApp